Fleischmann 56.20 Serie Instructions De Service page 15

4. Input ones' of the CV to be programmed (i.e. for CV123 input 3)
5. Operate the directional reverse on the controller
6. Front light flashes three times in series per second
7. Input hundreds' and tens' of the value for this CV
8. Operate the directional reverse on the controller
9. Front light flashes four times in series per second
10. Input the ones' of the value for this CV
11. Operate the directional reverse on the controller
12. Front light flashes one time per second
Input next CV and program it or terminate programming by switching off the track
voltage.
6.2 Programming with Märklin**-Mobile Station:
Attention!
The database of the Märklin**-Mobile Station contains only Märklin**-locos.
To attach Fleischmann locos to the database, please use either one of the uni-
versal numbers 36330 or 37962. Follow the next steps to set them up:
Attach loco to database:
1. Control knob must be positioned on "0"
2. Press "ESC"-button
3. With control knob to menu item "New Loco"
4. Press control knob
5. With control knob to menu item "Database"
6. Press control knob
7. With control knob select one of the two universal numbers (beginning with 36330
is recommended)
8. Press control knob
Set up the correct address:
1. Press "ESC"-button
2. With control knob to menu item "Change Loco"
3. Press control knob
4. Select menu item "Address"
5. Press control knob
6. Select address of the loco
7. Press control knob
If the loco does not drive now, delete it from the database:
1. Press "ESC"-button
2. With control knob to menu item "Delete Loco"
3. Press control knob
4. Press control knob again for confirmation
Then repeat the following steps:
"Attach loco to database" (1-8) und "Set up the correct address (1-7) with number
37962. If there are still problems, delete the loco from the database, again.
Then repeat the following steps:
"Attach loco to database" (1-8) but in step 5. select menu item "Address" and in step
7. select the address of your loco. Search the desired symbol by using the control knob
and confirm by pressing the control knob.
Functions F1 - F4 are called up by pressing the 4 left buttons of the Märklin**-Mobile
Station. The top button matches function F1. The activatet functions cannot be dis-
played.
Operation with an analog Märklin-transformer:
In order to reverse the direction with a Märklin-transformer it is essential, that the loco
has come to a complete standstill.
Detailed information are also available at www.zimo.at
* "Motorola" is a protected trademark of Motorola Inc., Tempe-Phoenix (Arizona/USA).
** "Märklin" and "Delta-System" are registered trademarks of Gebr. Märklin & Cie
GmbH, Göppingen.
*** "RailCom" is a registered trademark of Lenz GmbH, Giessen
13