Rockwell Automation Allen-Bradley MobileView MT750 Guide De Mise En Route page 16

16 MobileView Machine Terminal MT750
Inserting the PC Card
Locking Lever
PC Card Cover
a
Unlocking PC card cover (see illustration 1).
a. Lay the MobileView with the display facing down onto a flat, clean table
(preferably on ESP pad). Take care not to damage the terminal and its
elements.
b. Lift up on locking lever until PC Card Cover is released.
4. Inserting PC card (see illustration 2).
a. Lift the cover up.
b. Insert the PC card until it locks in and the ejection button pops out.
ATTENTION
!
5. Close and lock the cover (see illustration 3).
6. Press the cover down until it snaps in completely (see illustration 4).
Publication 2727-QS003E-MU-P
c
b
Verify that the corner of the PC card (with the notch) is
inserted into the slot on the side of the ejection button.
Check the condition and position of the cover seal before
closing the PC card cover.
1
a
b
3
2
Ejection button
4
Must snap
completely.