Rockwell Automation Allen-Bradley MobileView MT750 Guide De Mise En Route page 14

14 MobileView Machine Terminal MT750
The following illustration shows what the connection area of the MobileView
terminal looks like with the back cover removed.
RS-232 Port
for downloading software.
Main connector (S19)
for power supply and
control lines
Important: Install plug on
unused MobileView
Connection Cable outlet.
Relocating MobileView Connection Cable
The MobileView Connection Cable can be attached on the right or left side of the
terminal for right or left-hand operation. To relocate the cable, simply grasp the
strain relief and/or the plug and slide off of mount with a rocking motion.
Attaching Cable on Right
Avoid routing cable
over T-support.
Important: Make sure the K3, 11-pin female connector clicks completely into S19, Main Connector when
plugged in. Ensure proper seating of K2, 8-pin RJ-45 jack into S4, Ethernet Connector. Avoid routing cable
over T-supports. After routing the cable, secure the back cover to the terminal with the 6 screws. Tighten
screws to a torque of 0.5 Nm to maintain IP54 degree protection.
Publication 2727-QS003E-MU-P
Reset Button
for rebooting Windows CE.
All data not flushed to Registry or
saved to Flash Storage is lost.
pin 1
Ser i al
por t R eset
S19
B5
B4
00: 60: B5: 06: 00: 01
Position of switches does not
affect terminal operation (for
future use)
Ethernet connector (S4)
for data exchange
S4, Ethernet Connector
Ethernet Label
Ethernet (Mac) Address
AABBC C D D EEFF
2250- 00001
B2 B6 B3
Connector (not used)
Strain Relief
for connecting MobileView
Connection Cable (on left or right side)
Attaching Cable on Left
S19
Main
Connector
Cable Tag
Allows the terminal to
be uniquely identified.
Avoid routing cable
over T-support.