Troubleshooting - Midland WR400 Manuel Du Propriétaire

WR400 Owner's Manual

Troubleshooting

Problem
No power
No sound
No weather broadcast
when you press
WEATHER/ SNOOZE
button
The radio is not
responding properly
to NWS weather alert
broadcasts
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, (2) this device must accept any
interference recieved, including interference that may cause undesired operation.
NOTE: CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE
FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
This device containes lincence-exempt transmitter(s)/reciever(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions: (1) This device may not cause
interference, (2) This device must accept any interference, including interference that
may cause undesired operation of the device.
page 9
Suggestion
Make sure the AC Power Adapter is securely plugged into both the DC jack on
the back of the weather radio and into the wall outlet. Make sure batteries
are installed in case AC power fails.
Check VOLUME control to ensure volume is turned up to an audible level.
Ensure that the telescoping antenna is up and fully extended.
If you are using an external antenna, ensure that it is connected properly.
Ensure that the radio is set to the NWS weather channel in use in your area.
Contact NWS to ensure they are presently broadcasting.
If in a metal structure, make sure you are close to a window.
If in a weak signal area, you will need an external antenna.
Check to see that you have programmed in the correct S.A.M.E. County
Code(s).
Check with the NWS that the tower is broadcasting.
midlandusa.com