Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
Your fan comes fully assembled and ready for installation. Casement and sliding
windows require a mounting bracket for installation which can be found in the
hardware packet provided.
Your fan has been designed to fit double hung, casement or sliding windows with
minimum openings of 23" wide x 12" high (58cm X 30cm). Casement or sliding
windows require minimum openings of 12" x 23" high (30cm X 58cm).
DOUBLE HUNG WINDOWS
• Open your window at least 12" high (30cm).
• Turn the fan so that the front faces you. With the power cord hanging inside
your room, position the lower edge of the fan in the window. Lower the
window to the top of the fan. NOTE: Be sure the window is seated
between the window guides protruding from the top of the fan
(Fig. 1).
• Pull out each side panel until the space on the sides of the fan are fully blocked.
• To push the side panels back into the fan, pull out each tab on the back
side of the fan (Fig. 2). In this "pulled-out" position you can easily slide the
side panels back into the fan. The tabs should then be returned to the normal
position to secure the side panels in place.
WARNING: To prevent personal injury and/or damage to the fan,
never lean or push on fan while it is sealed in the window or during
operation. Do not lift the window while the fan is operating. Be sure
that the fan is fully secured in the window at all times.
Fig. 1
WINDOW
GUIDE
Fig. 2
TAB
Publicité
