Haussmann Xpert MJ10250IIIA Guide De L'utilisateur page 66

Set Screws
Latches
fig.36
- Latches Lock and Unlock Blade Guard and
Pawls to Riving knife
fig.37
fig.38
fig.39
ASSEMBLY
INSTALL MITRE GAUGE
Refer to Figure 37.
• The mitre gauge comes preassembled. Unpack the mitre gauge and clean
thoroughly. Insert into storage slots on right side of cabinet.
INSTALL PUSH STICK
Refer to Figure 38.
• Insert the push stick into brackets on left side of base.
INSTALL RIP FENCE
Refer to Figure 39.
• Position rip fence assembly at end of saw. Be certain locking lever is in
UP unlocked position.
• Place rip fence assembly onto rails, positioning clamp over rear rail and then
placing rip fence onto front guide rail.
• Rip fence should now ride freely on rip fence rails. Once rip fence is completely
installed, it should be parallel with the mitre gauge and perpendicular to the table.
If not, refer to "Rip Fence Adjustment" in the Operation section of this manual.
65