Service And Cleaning; Technical Specifications; Warranty - exodraft RSV Serie Mode D'emploi

3000113 RSV DK DE NO SE UK NL FR 120515

1.4 Service and cleaning

The motor in the RSV fan has special ball bearings that are sealed, lifetime lubricated, and maintenance-free. Any repla-
cement of these bearings should be carried out by qualified professionals.
The fan should be checked and cleaned as required (at least once a year), depending on the fuel being used. Respect
the following procedure:
• Use the isolation switch to switch off the fan. Wait until the fan stops rotating
• Loosen the screw and open the top section of the fan so that it hangs on its hinges and the safety
wire
• Using a scraper or brush, carefully clean the vane / centrifugal impeller
• Check the path taken by the smoke through the top and bottom sections of the fan for soot de-
posits, and clean where necessary with a scraper or brush
• When the fan is open it is also possible to sweep the chimney. In the case of the RSV160-450 it is
recommended that the insert in the bottom section be removed prior to sweeping. This allows
better access to the chimney
• Check that there is free access for fresh air to the motor through the holes in the top section.
Make sure that any weights on the centrifugal impeller are not removed.
RSV009-012-014-016

1.5 Technical specifications

The sound level is below 68 dB at a distance greater than five metres away from the RSV fan when it is correctly fitted.
Further information is available in the catalogue.
The standard version of the RSV fan is designed to operate with a maximum flue gas temperature of 250 °C. At higher
temperatures, though maximum 300 °C, the mineral wool mat should be replaced with adjusting screws (type RSD) or
vibration dampers (type SVD.-RS) at the flange. See special guidelines for these parts.

1.6 Warranty

exodraft provides a two-year factory warranty on its flue gas fans, valid from invoice date.
exodraft fans must be installed by competent personnel.
exodraft reserves the right to introduce changes to these guidelines without prior notice.
RSV160-200-250-315-400-450
UK • 9