Uk - Product Information; Construction And Design - exodraft RSV Serie Mode D'emploi

3000113 RSV DK DE NO SE UK NL FR 120515
1. UK – Product information
The exodraft RSV type chimney fan is supplied with location brackets, armoured cable, safety wire and a mineral wool
mat, as well as packing to ensure the fan does not vibrate. (Two wing screws are also included, to be used where condi-
tions allow).
Bad lighting habits can result in problems with soot, chimney fires, etc. which might damage the chimney fan. Please
see our advice about lighting and maintaining a fire at www.exodraft.com or www.exodraft.co.uk.
Warning!
• All installations must be carried out by competent personnel in
accordance with national laws and regulations
• Avoid chimney fires – ensure that the chimney has been swept before mounting the fan
• The chimney fan should always be switched on when the fireplace or boiler is in use
Please always read the installation instructions for the exodraft control unit, before installation of the
•
chimney fan.
• If the exodraft fan system has been designed for solid fuel/multi fuel installations then please ensure
the design meets the requirements of BS EN15287-1. If this can not be achieved, then a smoke alarm
must be installed in the same room as the appliance.
• exodraft would always recommend the use of a smoke alarm when a solid fuel open fire is installed
• Avoid build up of soot and tar use only well seasoned wood (moisture content max 20 %)
• Fans serving biomass boilers will inevitably receive a deposit from the appliance. Especially on bio-
mass Boilers IT IS ESSENTIAL THAT A REGULAR INSPECTION AND CLEANING REGIME IS IMPLEMENTED,
ESPECIALLY IN THE EARLY DAYS OF USAGE, TO ESTABLISH A PATTERN FOR TIMING OF REGULAR IN-
SPECTIONS AND CLEANING.
• Minimum distance to non-combustible material as per Fig. 4 A, or according to national legislation.
min. 0,8m

1.1 Construction and design

The casing is manufactured in cast aluminium, the RSV fan is designed for vertical discharge. It is available in ten sizes:
the RSV009, 012, 014, 016, 160, 200, 250, 315, 400 and 450. The axial vanes on the RSV009 – 016 are made of stainless
steel; the centrifugal impeller on the RSV160 – 450 is cast in aluminium. Both types can be opened for service and main-
tenance.
Weight:
Fan type Weight
RSV009-4-1 13 kg
RSV012-4-1 17 kg
RSV014-4-1 24 kg
RSV016-4-1 33 kg
min. 1,7m
Fan type
RSV160-4-1
RSV200-4-1
RSV250-4-1
RSV315-4-1
RSV400-4-1
RSV400-4-2
RSV450-4-2
Fig. 4 A
Weight
14 kg
18 kg
27 kg
37 kg
47 kg
58 kg
67 kg
UK • 3