Publicité
Les langues disponibles
Les langues disponibles
GB
Programming the personalized radio code
The installation radio code is coded by programming
■ Use the personalised radio code selected for the control panel.
Key presses
Personalised radio code
Remote control code
On the "remote control code" line sketch beneath each cross the
symbol
corresponding to the "Off" button.
■ Complete the empty slots by sketching the
ponding to the Total Arm button.
You now have a series of
the programming code.
■ Program the radio code by pressing the keys on the detector as
indicated below:
1. Start
2. Enter the
programming
sequence
by pressing
of 10 short key
both keys
presses
simultaneously
corresponding to
until the indicator
the personalised
light goes out
radio code
If you make a mistake, the red indicator light will flash.
Repeat the procedure from the beginning.
Ex. (not to be used): you have chosen the connections 2, 7 and 8.
Key presses
Personalised radio code
Remote control code
You now have a series of
entered on the remote control.
18
1
2
3
4
5
6
7
symbol corres-
and
symbols corresponding to
. . .
3. Confirm the programming
by pressing both keys
simultaneously until the indicator
light goes out. The indicator light
will come on for 5 secondes
to indicate the programming
has been successful
1
2
3
4
5
6
7
x
x
and
which is the code to be
■ For programming this example, carry out the following sequence:
8
9
10
Selecting programmable options
The Prog. key
take it out of its packaging.
You can choose to program one of the functions described in the
table.
Attention, this choice must be carried out according to the type of
control panel used.
Some of the control panel do not react to all these functions (you
can refer to the installation guide of the control panel).
Function
Alert call
Silent alarm
Audible signal
Light
■ For programming the key Prog., carry out the following sequence:
1. Start
programming
by pressing
both keys
simultaneously
8
9
10
until the indicator
light goes out
x
If you make a mistake, the red indicator light will flash.
Repeat the procedure from the beginning.
is programmed for the Alert Call when you
Reaction of the system
Triggers all means of alert (sirens, telephone dialer
interface,...)
Triggers telephone dialer interface only, without the sirens.
This use is particularly suited to the protection of the ill or
aged people
Triggers an audible beep on the control panel
Activation of 230V command receiver
. . .
2. Enter the
3. Start
sequence
programming
of 8 short key
by pressing
presses
both keys
corresponding
simultaneously
to the selected
until the indicator
function
light goes out
GB
4. Press
the Prog. key.
The light then
comes on again
for 5 seconds to
indicate successful
programming
19
Publicité
