Using Your Veinwalker; Cleaning And Looking After Your Veinwalker - GlobalMIND VeinWalker Mode D'emploi

L'appareil de massage complet pour réduire les affections veineuses et la cellulite – à un prix très avantageux
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Using your VeinWalker

If the medical grounds warrant it, please consult your doctor.
When you use your VeinWalker
to
minutes – depending on how you feel. If you have an unpleasant feeling
20
30
during the session, reduce the pressure or break off treatment.
After each session is over, fi rst of all turn the left rotary switch in an upward di-
rection
. The air will now be sucked out of the cuffs. After approximately one
minute you can open the zip and take off the cuffs. Let the pump continue to run
until the air is completely pumped out of the cuffs. This means you do not have
to go to all the trouble of pressing the air out yourself. Once the cuffs have been
pumped empty, turn your VeinWalker
from the control unit.
If necessary, clean the cuffs and then carefully fold them up. Try to avoid bend-
ing the cuffs too sharply – this could ultimately cause the cuffs to split after being
used for some time.

Cleaning and looking after your VeinWalker

Before cleaning your VeinWalker
the control unit and the cuffs. Should you sweat a little under the cuffs, you can
clean them with a dry (or slightly moistened) cloth and some cleanser. When the
cuffs are applied directly on the skin, you should disinfect them with a commonly
available disinfectant so as to avoid cross-contamination if they are to be used by
several different individuals. But never use astringent cleansers. In particular be
sure that no moisture fi nds its way into the openings for letting air in and out.
You should make a point of plugging the openings with the stoppers when you
clean the cuffs.
After your VeinWalker
could begin to widen out with the result that they are no longer airtight. In such a
case you can cut a short piece off the ends.
Fold up the cuffs only loosely. If the cuffs are bent too forcefully, they could split.
We recommend cleaning the control unit only when it is necessary. Clean the
control unit in the same way as you clean the cuffs. The cuffs can be cleaned after
each session or at regular intervals.
Always remember to pull the plug out before you clean your VeinWalker
03491_DE-GB-FR-NL_BDA_A5_V4.indb 33
03491_DE-GB-FR-NL_BDA_A5_V4.indb 33
©
, we recommend that each session should last
©
off O. Now you can remove the hoses
©
©
, you should always disconnect the hoses from
has been in use for a long time, the ends of the hoses
©
33
©
!
©
26.02.2014 10:43:49
26.02.2014 10:43:49

Publicité

Table des Matières
loading

Table des Matières