Wireless Pairing Operation - Harmony Hi Lo Manuel D'assemblage Et D'utilisation

Wireless pairing operation

Step1:
Open the battery compartment on the Remote Control. Remove the yellow sticker,
which covers DIP Switch. Push the DIP Switch on the Remote Control to a certain
position (different from the position on the other Remote Control paired with it near
both Control Boxes.) and put three AAA batteries into the Remote Control.
Step2:
Connect the Control Box to the SMPS. Plug its AC Main Cable to the Power Outlet.
Step3:
Press and hold the LINK BUTTON on the Control Box until the LINK LED on the Control
Box turns off. Then release the Link Button and the LINK LED turns flashing. That
indicates the Control Box is pending to be paired.
Step4:
Press and hold simultaneously the button
Control until backlight turns flashing. Release the two buttons and the backlight LED
continue flashing and search the pending Control Box where the LINK LED is flashing.
Once both the backlight on the remote control and the LINK LED on the control box stop
flashing, the pairing operation is completed.
Please repeat the all above steps if the pairing operation failed.
Important Notes:
1.
It is strongly recommended, if multiple Bases are being used in the
same house or area, each Base should be configured differently. Each
Control Box must be paired with the different Remote Control where
the DIP-Switch position is different. Do not pair both Controller with
the same Remote Control or movement could occur on additional Base
unexpectedly.
2.
It is important if two Control Boxes (Split King) are expected to work
synchronously, they must still be configured differently to pair with
different Remote Controls with different DIP-Switch position. Do not
pair both Control Boxes to work with the same Remote Control.
and the button
18
on the Remote