Table des Matières
Publicité
®
R&S
NGE100
For safety reasons, the instrument may only be connected to properly installed
safety socket outlets. Separating the grounds is prohibited.
The power plug must be inserted before signal circuits may be connected.
Use only the power cord included in the delivery package. See
package"
on page 13.
Before each measurement, measuring cables must be inspected for dam-
age and replaced if necessary. Damaged or worn components can damage
the instrument or cause injury.
The product may be operated only under the operating conditions and in the posi-
tions specified by the manufacturer, without the product's ventilation being
obstructed. If the manufacturer's specifications are not observed, this can result in
electric shock, fire and / or serious personal injury, and in some cases, death.
Applicable local or national safety regulations and rules for the prevention of acci-
dents must be observed in all work performed.
The instrument is designed for use in the following sectors: Industry, residential,
business and commercial areas and small businesses.
The instrument is designed for indoor use only. Before each measurement, you
need to verify at a known source if the instrument functions properly.
To disconnect from the mains, the low-heat device socket on the back
panel has to be unplugged.
See
Table 3-1
for the general data on the instrument specification. For more infor-
mation, see the instrument product brochure (PN: 5214.8748.12).
Table 3-1: General data on instrument specification
General data
Mains nominal voltage
Power consumption
Mains fuses
Temperature
Getting Started 5601.1308.02 ─ 04
AC
Maximum input power
115 V AC
230 V AC
Operating temperature range
Putting into Operation
Intended Operation
"Delivery
115 / 230 V (±10 %) 50 / 60
Hz
180 W
IEC 60127-2 / 5 T 5 A 250 V
IEC 60127-2 / 5 T 2.5 A 250 V
0 °C to + 40 °C
11
Publicité
Table des Matières
