Toto CT708U Manuel D'installation Et D'utilisation page 6

6. Place the toilet on the carrier
bolts.
7. Place the loosened washers
and threaded caps on the
carrier bolts.
8. Check that the toilet is level.
9. Firmly hand tighten the
threaded caps and washers
on the bolts that contain the
mounting nuts and washers.
Then use a wrench to
tighten approximately
1/4 turn.
CAUTION: Do not over
tighten the nuts, this can
break the china.
10. Install flush valve according
to the manufacturer's
instructions.
11. Turn the water supply back
on and flush toilet several
times and check for water
leakage.
12. Caulk the edges of the toilet
to finish the installation.
INSTALLATION PROCEDURE
6
ill. 4
ill. 5
ill. 6