Cleaning - Imetec C7003 Mode D'emploi

Curly effect
• Insert one of the three available curling tongs (15, 16, 17)
onto the heating element (1) keeping the supporting hook
downwards.
• Take a thin lock of hair between your fingers; the thinner
the lock, the tighter the curls.
• Open the curling tong lever and completely wrap the lock
of hair onto the cylinder, then close the lever.
• Wait a few seconds for the lock of hair to acquire the
desired style, then release it from the iron by opening the
lever.
• Finish off the style of the curl with your hands.
Sculpted ringlets
• Insert the medium curling tong (16) onto the heating
element (1) keeping the supporting hook downwards, then
insert the spiral accessory (14).
• Take a lock of hair, open the lever of the curling tong and
lock the end of the lock of hair between the cylinder and
the lever.
• Wrap the lock of hair around the spiral by rotating the
multistyler.
• Open the lever after a few seconds and release the lock of
hair by unwinding it from the spiral.
• Style the ringlet you have obtained with your hands.
Frisé effect
• Insert the frisé effect irons (10) into the iron support (8) and
ensure the upper and lower part suitably match.
• Insert the straighteners support (8) onto the heating
element (1).
• Take a thin lock of hair, as wide as the plate and not too full,
and place it between the two plates.
• Press slightly.
• Move the styling plate down, taking care not to overlap
already styled hair.
• Repeat the procedure for the entire length of the lock of
hair.
• Switch off the appliance by moving the 0-1 button (5) onto
position 0 and unplug the appliance from the socket.
• Wait for the accessories to be cold and pull them out of the
heating element (1).
• Clean the surface of the accessories and the handle (4)
with a soft, damp cloth.
ATTENTION!
Make sure all cleaned parts are completely
dry before reusing the appliance.

CLEANING

15
EN