Table des Matières
Publicité
28—Possibilités d'extension du VS-2400CD
Installation Procedure
Always turn the unit off and unplug the power cord before attempting installation of
the circuit board (VS8F-2, Page 78).
During installation of a VS8F-2, be careful not to touch the VS-2400CD's battery.
1. Before installing the VS8F-2, turn off the power of the VS-2400CD (Page 78) and all
2. Turn the VS-2400CD over onto its back, and remove only the screws shown in the
3. Inside the VS-2400CD, there are two connectors and 6 plastic pins for the VS8F-2.
4. Use the screws that you removed in Step 2 to re-fasten the bottom cover.
5. Connect the cables that you disconnected earlier.
6. Turn on the power, as described on Page 63.
7. After powering up the VS-2400CD, hold down SHIFT and press F3 (EFFECT), and
If the effect produced by an installed VS8F-2 is missing—and the screen shows "No
EFFECT Board" instead—the VS-2400CD is not correctly recognizing the VS8F-2. Re-
install the VS8F-2.
376
connected devices, and disconnect all cables from the VS-2400CD.
following diagram.
Lithium Battery
EFFECT B
Insert the connectors of the VS8F-2 into the internal connectors, and
simultaneously insert the plastic pins into the holes of the VS8F-2 to fasten the unit
in place.
confirm that you see effect patch symbols for Effects 1, 2, 3 and 4.
EFFECT A
EFFECT A
When turning the unit
upside-down, take care to
avoid dropping it or
allowing it to fall over.
Should you remove ground
terminal screw and bottom
cover screws, make sure to
put them in a safe place out
of children's reach, so there
is no chance of them being
swallowed accidentally.
OK
NG
Publicité
Table des Matières
