Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OVERVIEW
The PRS
110
The charging procedure occurs in two steps:
Step 1:
Battery charge
(14.1Vd.c.)
NOTE: the end of charge voltage is reached only if batteries are efficient.
Maintenance
Step 2:
OPERATION INSTRUCTIONS AND INSTALLATION
- The instrument shall be used for the regulation of photovoltaic modules charging only.
Connection to other equipment which can damage the correct operation may result in warranty void.
-
Note
: the PRS 110 regulator is not suitable for the charging of nickel/cadmium batteries, lithium batteries
without integrated electronics or other kinds of rechargeable or non rechargeable batteries.
- The regulator is not suitable for external use.
- Install the regulator in an appropriate dry and ventilated housing; make sure there is a minimum distance
of 300mm from the front and 100mm from the sides to the surrounding surfaces.
- Do not cover air intakes on the lid.
- The instrument produces heat during normal operation. Make sure that the installation of other equipment
near the instrument does not hamper the correct air flow and prevent the necessary instrument cooling.
- Use cables with the appropriate section (recommended section 6mm² for photovoltaic module).
- Protect the cables from any possible damage.
IMPORTANT:
- The equipment shall be installed by qualified technical personnel only.
- In the event of instrument wrong use, the warranty shall be void and the manufacturer declines any
responsibilities for damage to things or persons.
- Exhausted batteries shall be disposed of according to environmental protection regulations in force.
- Solar cables should be placed away from the cables for Radio/TV/SAT antenna.
PRS 110 SOLAR REGULATOR
1)
Yellow led:
module is charging the battery (step 1).
2)
Green led:
maintenance stage at constant voltage
GB
(step 2).
GB
4
charge regulator can automatically charge lead batteries at 12Vd.c.
with photovoltaic module maximum current, until the end of charge voltage is reached
at constant voltage 13.5Vd.c.
PRS 100
REGULATOR
FOR SOLAR
MODULES
CHARGE
FLOAT - OK
SYSTEM VOLTAGE 12V
SOLAR MODULES
10
0W
SPECIFIC ATIONS
indicates that photovoltaic
indicates the charge
1
2
w
w
w
w
w
w
w
w
w
photovoltaic module (
and 12V leisure battery (
-
-
12V
2
TECHNIC AL DATA
Rated voltage 12Vd.c.
Self-consumption 0,01mA 12Vd.c.
Working temperature: -10°C +60°C.
Serial control with Mosfet.
Schottky blocking diode
Applicable panels: max 110W.
Electronic protection for short-circuits and
poles inversion.
Dimensions (mm): 115x88 H37.
Weight (gr): 120.
Connection for
)
)
12V
110W
(max)
Publicité
Table des Matières
