Amann Girrbach ap100 Mode D'emploi page 7

OperaTIng InsTruCTIOns
ap100 surVeyOr
Translation of the original operating instructions
Setting ring
!
@ Hinged arm
# Pillar
$ Surveying head
% Milling head
^ Surveying head/milling head setting and
height adjustment screw
Chuck knurled nut
&
Opening for adapter cable bush
*
Adapter cable bush set screw
(
On/Off switch
BL
Blockout heating controller
BM
Model platform magnet on/off switch
BN
BO Surveying head setting and height
BP Handpiece adapter sleeve set screw
BQ Spring bolt
accessories:
% Milling head
Handpiece adapter sleeve set screw
BP
Spring bolt
BQ
prODuCT DesCrIpTIOn
The AP100 is a universal surveyor for
the following applications:
_ Surveying models
_ Marking undercuts
_ Carving wax components
_ Positioning precision attachments
_ Transferring milled and attachment
components
_ Blocking out - When used with the
AP100 Block-out set
The magnetizable base plate in the base enables
the model platform to be fixed in place by simply
pressing a button. The AP100 also includes an
electric controller for heating the blocking out
components. The patented locking mechanism
of the hinged arm locks the two hinges exactly
and firmly with a screw. The centering wedge
on the setting ring can be used to swivel the
rigid arm outwards when, for example, chan-
ging instruments. When swivelled back, the
hinged arm resumes its previous position
exactly. Special bearings enable the hinged
arm and surveying head to move very smoothly.
The level of the surveying head can be adjusted.
An MT2 model platform is supplied with the
unit. The MT2 can be tilted by up to 90° in all
directions and fixed in any position. The "zero
degrees" position can be reproduced with a
locking mechanism. The AP100 block-out set
can be used with the AP100 for blocking out.
This set comprises a B2 Blockout holder, 5
gold-plated tips and an adapter cable.
The AP100 can also be equipped with a milling
head and an adjustable Halogenlamp.
unpaCk anD CheCk
After unpacking the unit, please check it imme-
diately for possible damage incurred during
transport. Should the unit have been damaged
during transport, please complain to your supplier
immediately. This unit is supplied ready for use.
MOnTage ap100
Place the setting ring
!
(pointing upwards) over the pillar and tighten
them. Place the hinged arm
of the base, making certain to position it parallel
and without wedging it. Loosen the spring bolt in
the milling head, rotate it through 180° and
re-attach it. Insert the surveying head
milling head into the hinged arm and tighten
%
it with the screw . This screw is also used for
^
setting the basic level of the surveying head.
The surveying head is tightened with the knurled
nut , for example, for placing an attachment.
BO
Rotary instruments (1 - 3 mm shanks) are tight-
ened with the chuck knurled nut
and centering wedge
on the pillar
@ #
or
$
.
&
gB
7