JBL Artemio Set Mode D'emploi page 11

6. Stopcock
7. Artemia sieve (also available separately as JBL Artemio 3)
8. Harvesting container (also available separately as JBL Artemio 2)
9. Air hose 4/6 mm
10. Aerator pump EcoAir 40
11. Non-return valve for air
12. Screws for wall mounting
Installation and operation of JBL Artemio Set
6
1. Select a suitable place to set up the equipment. If possible, the stand (1)
should be placed in a location which is not sensitive to water and is out of the
reach of children. Alternatively, select a place where the equipment can be wall-
mounted, fixing the stand (1) with the screws (12) supplied.
2. Open the domed lid of the brood container (3) turning clockwise (bayonet)
and remove it together with the extension hose (4a). Place the brood container
(2) in the stand so that the JBL logo and filling level mark are easily visible.
3. Fill the brood container (2) with tepid tap water (approx. 25 °C) up to the
filling level mark (500 ml). Put 3 measuring spoons JBL ArtemioMix into
the brood container. Alternatively you can also use 3 measuring spoons
JBL ArtemioSal and 2 – 3 measuring spoons JBL ArtemioPur. JBL
ArtemioMix or ArtemioSal and ArtemioPur are available from your
specialist retailer. Then close the domed lid, turning anti-clockwise.
4. Using the air hose (9) provided, connect the air inlet (4) on the domed lid (3)
to the aerator pump provided (10). If possible, position the aerator pump above
the water level in the brood container. If the pump can only be positioned below
the level of the water in the brood container, fit the supplied non-return valve to
the air hose, about approx. 5 - 10 cm away from the air inlet.
5. Connect the aerator pump to the mains power. The mixture of salt, Artemia
eggs and water in the brood container will now be vigorously aerated. This
vigorous aeration is necessary for the Artemia nauplii to hatch as successfully
as possible. The air supply should therefore not be reduced. At 25 °C the nauplii
hatch in approx. 24 hours, at lower temperatures, correspondingly slower.
6. After waiting for the corresponding time, turn off the air supply and wait until
the reddish nauplii have collected in the point of the funnel and the empty egg
cases have floated to the top. Open the stopcock (6) and let the nauplii run out
into the Artemia sieve and harvesting container positioned below. Using fresh
water, briefly rinse the nauplii in the sieve and then feed to the young fish.
DE
UK
FR
NL
IT
DK
ES
PT
SE
CZ
PL
RU
11