Siemens TS14 Serie Notice D'utilisation page 15

Cleaning the Boiler
To extend the life of your steam generator and
to avoid any build up of scale, it is essential that
you rinse out the boiler after several hours of use
(approximately after 50 hours). if the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check that the appliance is unplugged and cold
for more than 2 hours.
2. Unscrew the boiler´s cap (1)
3. Empty the boiler above a sink by holding the
appliance upside down.
4. Fill the boiler with 500 ml of fresh water.
5. Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
6. To obtain the best result, we recommend that
this operation is done twice
7. Close the cap
Cleaning & maintenance
Important:
always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. after ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. if the soleplate is soiled with dirt or scale, clean
it with a damp cloth.
4. never use abrasive products or solvents.
D
Storing the appliance
1. Set the main power to the "0" position and
disconnect the mains cable.
2. always allow the appliance to cool down before
storing it.
3. place the iron on the iron pad, standing on the
soleplate.
4. Empty the boiler and store the mains cable and
the steam hose in the storage compartment.
Do not wrap the cords too tight.
Fabric protection
E
soleplate cover
(depending on the model)
The fabric-protection soleplate cover is used for
steam-ironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for
a cloth to prevent shine on dark materials.
it is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place the
tip of the iron into the end of the soleplate cover
and pull the elastic strap over the lower rear of
the iron until it fits tightly. To release the soleplate
cover, pull the elastic strap and remove the iron.
The fabric-protection soleplate cover may
be purchased from the customer service or
specialist shops:
accessory code
(after-sales)
464927
advice on disposal
our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
your local town council can give you information
about how to dispose of obsolete appliances.
This appliance is labelled in accordance
with European Directive 2002/96/Eg
concerning used electrical and
electronic appliances (waste electrical
and electronic equipment - WEEE).
The guideline determines the framework for
the return and recycling of used appliances as
applicable throughout the EU.
Tips to help you save
energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
▪
Start by ironing the fabrics that require the
lowest ironing temperature.
▪
Check the recommended ironing temperature
on the label on the garment.
▪
regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
▪
Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
if you tumble dry your fabrics before ironing
them, set the tumble drier on the 'iron dry'
programme.
▪
if the fabrics are damp enough, turn off the
steam regulator completely.
name of accessory
(Specialist outlets)
TZ15100
SIEM ENS
15