Robern CRAFT Serie Mode D'emploi

CONTENTS
Parts - 2
Position the Vanity - 3
Level the Vanity - 3
Secure the Vanity - 4
Drawer Removal / Installation - 5
Drawer Divider Installation - 5
Drawer Adjustment - 6
Helden Installation Instructions - 7
Care and Maintenance - 12
Warranty - 12
GENERAL INFORMATION
This instruction manual contains information on how to install a Craft Series or Curated Bath Vanity. This series comes in various sizes.
These vanities need special site preparation. Do not install vanities until all framing and plumbing rough-ins have been completed and
the wall surface has been finished. We recommend using the services of a professional installer. Observe all local building codes.
Save these instructions for future use and reference. An improper installation voids the warranty. Installed vanities cannot be returned.
If you experience any problems with your Robern product, contact your dealer or Robern directly.
NOTES
NOTICE: Consult professional help if you are not familiar with installing bathroom cabinetry and working with associated plumbing
hardware and tools. After safely unpacking the vanity and hardware, make sure all parts are present. If any part is missing and/or
damaged, stop and do not attempt to assemble the product. If you experience any problems with your Robern product, contact your
dealer or Robern directly.
NOTICE: Risk of product damage. When moving the vanity, do not slide or side-load the legs.
• Observe all local building codes.
• The appearance of your vanity may differ from the illustrations in this guide. The instructions still apply.
TOOLS
© 2021 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
CRAFT SERIES VANITIES
CURATED BATH SERIES VANITIES
Important safety instructions - Save these instructions
1
Check the
dimensions of your
vanity before you
begin.
Scan the QR
code to find the
specification sheet
for your vanity.
Part no. 209-1416 07/21/2021
Craft Series & Curated Bath Vanity