LF Utilitech 6211W-PIR23A Mode D'emploi page 6

5. Make sure wire connections are secure. Carefully place wires
into junction box. Position the fixture (A) cover plate over the
crossbar.
Note: Put the long mounting screw removed in Step 2 through
the center hole and into the crossbar and tighten the screw until
secure. Insert mounting screw cap (CC) into mounting screw
hole. DO NOT overtighten.
IMPORTANT:
If wall mounted, make sure the fixture is mounted with the
sensor below the lamp heads.
If eave mounted, rotate the sensor 180° so the controls face the
ground.
Hardware Used
Mounting screw cap
CC
6.
Align the slots on the reflector (B) on the fixture body. Turn the
reflector clockwise until it locks into place.
x 1
6
5
A
5
5
A
6
B
CC
A
CC
A
B