Transporting And Storage; Troubleshooting - EarthQuake Edger 23275 Manuel De L'utilisateur

TRANSPORTING AND STORAGE

1. If fuel is present in the fuel tank, transport in an open vehicle
in an upright position.
2. If an enclosed vehicle must be used, remove fuel into an
approved red fuel container. DO NOT siphon by mouth.
3. Wipe away any spilled fuel from engine and edger. Allow to dry.
LONG-TERM STORAGE
(30 DAYS OR MORE WITHOUT USE)
If your edger will not be used for more than one month, prepare
it for long term storage.
STEPS FOR LONG-TERM STORAGE
1. Add fuel stabilizer according to manufacturer's instructions.
2. Run engine for 10-15 minutes to ensure that the stabilizer
reaches the carburetor.
3. Remove the remainder of the fuel from the gas tank into an
approved fuel container.
4. Remove all debris from the edger engine and blade guard area.
CAUTION
TO AVOID INJURY OR DEATH, NEVER SIPHON FUEL BY
MOUTH.
NEVER STORE ENGINE WITH FUEL IN THE TANK INSIDE
A BUILDING. POTENTIAL SPARKS MAY BE PRESENT
FOR IGNITION OF FUEL AND FUEL VAPORS.
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5

TROUBLESHOOTING

At Earthquake®, we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life for
your Earthquake® Edger. Most repairs will be minor, and easily
fixed by following the suggestions in the troubleshooting guide
in this section.
The troubleshooting guide will help you pinpoint the causes of
common problems and identify remedies.
For more complicated repairs, you may want to rely on an
authorized service center or Earthquake. Earthquake will make
the necessary repairs if a service center is not available.
We will always be glad to answer any questions you have, or
help you find suitable assistance. To order parts or inquire about
warranty, call or e-mail us using the contact information found
in this section.
SPARE PARTS
Only use approved Earthquake® service parts.
ORDERING REPLACEMENT PARTS
Parts can be obtained directly from the factory. To order parts
visit www.getearthquake.com or call 1-800-345-6007.
For other general questions, you can e-mail us at info@ardisam.com.
Please include the following information with your order:
1) Part numbers
2) Part description
3) Quantity
4) Model number and serial number
Operator's Manual
Edger
17