Convert From Lp Gas To Natural Gas - Jenn-Air JGC2530E Instructions

1. Turn manual shutoff valve to the closed position.
A
A. To cooktop
B. Shutoff valve (closed position)
C. Gas supply line
2. Unplug cooktop, or disconnect power.
To Convert Gas Pressure Regulator
A
A. Access cap
B. Rear of cooktop
C. Gas pressure regulator
D. Gas flow
3. Determine the type of regulator you have:
Style 1: The cap has a slot and "LP" printed on it.
Remove access cap by using a flat-blade screwdriver
or coin, turning the access cap counterclockwise.
The gas pressure regulator has 2 settings which are
stamped on either side of the cap. Turn the cap and
reinstall into regulator with the stamp "NAT" visible
from the outside of the regulator.
Style 2: The cap does not have a slot and requires
a wrench to be removed.
Remove the access cap by using a wrench, turning
the access cap counterclockwise.

Convert from LP Gas to Natural Gas

B
C
B
C
D
NAT
Remove spring retainer from the cap by pushing against
the flat side of the spring retainer. Look at the spring
retainer to locate the "LP" or "NAT" position. Turn over
the spring retainer so the "NAT" is showing on the bottom.
Snap the spring retainer back into the cap. Reinstall the
cap onto the regulator.
E D
A. Access cap
B. Gasket
C. Gas pressure regulator
D. NAT position
E. LP position
4. If they are installed, remove the burner grates.
Use the following chart to match the correct gas orifice spud
with the burner location and model being converted.
Natural Gas Orifice Spud Chart
Burner Rating Stamp (A)
1,300 BTU* 53
6,000 BTU 110
9,050 BTU 132
12,000 BTU 155
18,000 BTU 190
*Simmer orifice for the dual stack (center) burner.
Burner Models
Right Right
Model No.
front rear
JGC2530E
6,000 12,000
BTU BTU
JGC2536E
6,000 12,000
BTU BTU
A
B
C
Size
0.53 mm
A
1.10 mm
1.32 mm
1.55 mm
A. Size stamp
1.90 mm
Left Left
Center
front rear
18,000 9,050 12,000
BTU BTU BTU
18,000 9,050 12,000
BTU BTU BTU
7