Care And Maintenance; Warranty - Hilti DD-HD XC Mode D'emploi

7. Support the rail and release the locking screw until
the rail is free to move.
8. Slew the rail to the vertical position.
9. Tighten the locking screw.
10. Release the clamping lever.
11. Turn the square drive to move the carriage down-
wards until the centering point is pressed firmly
against the base plate.
12. Lock the carriage on the column by tightening the
clamping lever.
13. Check that all screws are tightened securely.

7. Care and maintenance

Disconnect the supply cord plug from the socket.

8. Warranty

Hilti warrants that the product supplied is free of defects
in material and workmanship. This warranty is valid as
long as the product is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti operating instructions, all warranty claims are
made within 12 months (unless other mandatory national
regulations prescribe a longer minimum period) from
the date of sale (invoice date) and the technical system
is maintained, i.e. only original Hilti consumables, acces-
sories and spare parts are used with the product.
This warranty provides the free-of-charge repair or replace-
ment of defective parts only. Parts requiring repair or
replacement as a result of normal wear and tear are not
covered by this warranty.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069651 / 000 / 00
6.14 Using the rotation device (accessory)
NOTE
This accessory allows the rail to be rotated about its
own axis.
1. Release the four hex. socket screws on the rail
clamp and remove the rail clamp from the carriage.
2. Use the four hex. socket screws to fit the rotation
device to the carriage.
3. Push the round pin from the rail securely into the
rotation device.
7.1 Care of metal parts
Clean off dirt and dust deposits adhering to the sur-
face of the cross-column adaptor and protect the parts
from corrosion by wiping them occasionally with an
oil-soaked rag.
Additional claims are excluded, unless mandatory
national regulations prohibit such exclusion. In par-
ticular, Hilti is not obligated for direct, indirect, inci-
dental or consequential damages, losses or expenses
in connection with, or by reason of, the use of, or inabil-
ity to use the product for any purpose. Implied war-
ranties of merchantability or fitness for a particular
purpose are specifically excluded.
Send the product and/or related parts immediately upon
discovery of a defect to the local Hilti marketing organi-
zation for repair or replacement.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
en
11