Publicité
Les langues disponibles
Les langues disponibles
SCM4480_27
05-03-2008
4
Functional overview (fig. A)
P P H H I I L L I I P P S S
1
• Lights up when a 5V device is charging (when no
device is connected, the PHILIPS logo will flash).
• Flashes when the device is fully charged.
F F o o l l d d a a b b l l e e p p o o w w e e r r p p l l u u g g
2
Connects to the wall outlet.
U U S S B B p p o o r r t t
3
Connects to 5V DC devices (mobile telephones,
MP3 players, etc.).
5
Operation
C C h h a a r r g g i i n n g g d d e e v v i i c c e e s s - - p p r r e e p p a a r r a a t t i i o o n n
Check the maximum input voltage (V DC) of the
1 1
device you wish to connect. For this see the user
manual that came with the device.
Make sure the device does not consume more current
2 2
(mA) than 350 mA.
3 3
Check what connector tip is required for your device.
See the compatibility sheet for the proper tip for your
device.
C C h h a a r r g g i i n n g g 5 5 V V d d e e v v i i c c e e s s (fig. B)
1 1
Insert the plug of the USB cable into the USB port (3).
2 2
Connect the connector tip to the USB cable.
3 3
Insert the connector tip into the power supply jack of
the device.
> P P H H I I L L I I P P S S lights up when a device is charging.
> P P H H I I L L I I P P S S will flash when the device is fully charged.
4 4
Disconnect the device from the USB charger.
Disconnect all cables from the device and from the
5 5
USB charger.
15:44
Pagina 5
6
Technical specifications
• Rated input: 100V - 240V AC (50/60Hz), 0.2A
• Rated output: 5.4V, 350 mA
• Operating temperature: -10ºC - 40ºC
• Size: 70.3 x 55.5 x 35.5 mm (h x w x d)
• Weight: 70 g
• Maximum battery capacity for charging is 1,200mAh,
battery type is Li-Ion or Lithium Polymer
• Power consumption:
- in Off mode: 0 W;
- in Standby mode: 0.25 W.
7
Troubleshooting
P P r r o o b b l l e e m m
– Possible cause
• Solution
U U S S B B c c h h a a r r g g e e r r d d o o e e s s n n o o t t c c h h a a r r g g e e c c o o n n n n e e c c t t e e d d d d e e v v i i c c e e
– Voltage of device does not correspond with that of USB
charger.
• Refer to the user manual that came with the device.
– Improper connection between device and USB charger.
• Make sure that the USB cable is properly inserted into
the device and the USB charger.
– Damaged USB cable or connector tip.
• Replace USB cable and/or connector tip.
– Wrong connector tip used.
• Check connector tip and replace if necessary.
– Non supplied USB cable / connector tip used.
• Replace with supplied USB cable/connector tip.
– Problems with electrical circuit of USB charger.
• Take the USB charger to your local distributor.
5
Publicité
