Attaching Mounting Plate To Display With Vesa 75 Or 100 Mounting Pattern - peerless-AV PC930A Installation Et Montage

Attaching Mounting Plate to Display with VESA 75 or 100 Mounting Pattern

Note: For VESA 200 x 100 mm and 200 x 200 mm hole patterns, see following page.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
Choose hole pattern as shown in fi gure 5.1 which matches hole pattern on back of your display. Attach tilt bracket
5
(F) to back of display using four M4 x 10 mm screws (M) or M4 x 12 mm screws (N) as shown in fi gure 5.2.
*NOTE: If hole pattern is in a pocket, attach tilt bracket (F) to back of display using four M4 x 20 mm screws (O)
and four retaining spacers (P) as indicated in fi gure 5.2.
Skip to step 6.
FOR VESA 75 MOUNTING PATTERN:
FOR VESA 100 MOUNTING PATTERN:
fi g. 5.1
WARNING
fi g. 5.2
F
M, N or O
8 of 35
*For displays with a hole
pattern in a pocket, spacers
go between tilt bracket and
display when used with
M4 x 20 mm screws (O).
ISSUED: 11-29-07 SHEET #: 202-9263-2 08-17-11
P