Adjusting Display; Install Cable Covers - peerless-AV PC930A Installation Et Montage

Adjusting Display

If screws indicated are fully tightened, loosen screws half a turn to allow for adjusting tilt, swivel and roll. Adjust
8
display to the desired position and fully tighten screws.
• Do not loosen adjustment screws to the point they become disengaged from the mount. Weight of the display
should be supported in case of accidental disengagement.
ROLL ADJUST M EN T
BACK VIEW
SCREWS FOR
ROLL ADJUSTMENT
6° (±3°) ROLL

Install Cable Covers

NOTE: Be certain mount is in the desired
9
extended position.
Attach cables to display if routed through
channels.
Cut cable covers (G) to the length of inner
channel (C) and outer channel (B) openings,
leaving space for cables if routed through
channels. Snap cable covers into openings as
shown.
Cables not routed through channels will
require cable ties (not included).
WARNING
TILT A D JU STMEN T
SIDE VIEW
SCREWS FOR
TILT ADJUSTMENT
(BOTH SIDES)
SLOT ALLOWS FOR
INCREMENTAL TILT
ADJUSTMENTS OF 5°
25° (+20°/-5°) TILT
11 of 35
All other brand and product names are trademarks or registered trademarks of their respective owners.
SWIVEL AD JU STMEN T
BOTTOM VIEW
SCREWS FOR SWIVEL ADJUSTMENT
90° (±45°) SWIVEL
G
CUT TO
LENGTH OF
OPENING
C
ISSUED: 11-29-07 SHEET #: 202-9263-2 08-17-11
© 2011, Peerless Industries, Inc. All rights reserved.
B
G
CUT TO
LENGTH OF
OPENING