Getting Started; Operating Instructions; Picture Mode - Braun DigiFrame 1361 Mode D'emploi

3. Getting Started

3.1 Plug one end of the included AC adapter into a standard
110-240V AC electrical outlet and the other end into DC
in of the photo frame.
3.2 Remove the protective film covering the LCD.
3.3 Remove the plastic battery insulator from the battery
compartment and make sure the remote control has
a battery inside. Please refer to "Installing & Replacing
Battery" if you need a new battery.
3.4 Power on the unit by pressing the Power button on the
remote control.

4. Operating Instructions

After turning the Units, it will show the start-up logo, and
then show the main interface after 3~5 seconds. If there
are picture and music's in USB/SD or memory, it will play
the slideshow and enter the main menu after pressing
RETURN button.
4.1 Main Menu
After showing the start-up picture, it will automatically enter
the main menu
Total 5 icons:
Photo,
Music,
Video,
Calendar,
Setup
E N G L I S H
USB and Memory Card
The unit supports SD/MMC/MS and USB 2.0. Press Enter to
select the source device
NOTE:
1) Make sure there are supported picture, music and video
files in the Card or USB device.
2) You can also select Auto-play Photo, Music, Movie or
Photo + Music, off in the Setup Menu.

5. Picture Mode

Highlight Photo from the main menu or press the PHOTO
button on the remote control to display the photos stored
on the USB drive or SD card. Press the EXIT button on the
remote control to display the photo file list of the memory
device.
Press 5634
displayed and press ENTER to display the photo. Press the
EXIT button on the remote control to display the memory
device menu. Press
device (card/USB) and press ENTER to display the photos
stored on this device.
Picture Playback
When playing the single picture, press Toolbar to enter
information bar and set up the item.
to highlight and select the photo to be
34 to highlight and select the memory
13