Simplicity VACUUMS S65S Manuel Du Propriétaire page 7

ASSEMBLING THE VACUUM
WARNING: The S65 battery included
can only be used with the S65 model as
intended.
Installing the Battery
Push the battery into the battery
compartment until it clicks into place
(Fig. 1).
Removing the Battery
Press the two battery release buttons
and pull the battery pack out of the
vacuum (Fig. 1).
Charging the Battery
(S65S and S65D)
The battery is partially charged and will
run for a short time.
1. Set the vacuum onto the Storage/
Charging Station, ensuring the
connection between points on vacuum
with Storage/Charging Station (Fig. 2).
2. Plug the battery charger into the
Storage/Charging Station and into
an electrical outlet (Fig. 3). The
indicator light on the battery will
be red while the battery is charging.
When the indicator light is blue,
the battery is fully charged (Fig. 4).
Charging time is approximately
4-5 hours.
3. Remove the battery charger from
the vacuum and begin vacuuming.
Battery Indicator Light
Solid Blue = Fully Charged
Solid Red = Low Battery
(S65S AND S65D)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
5