Heath Zenith 7366 Mode D'emploi page 5

3. PROBLEM: Chime sounds when not intended (false triggers).
POSSIBLE CAUSE: Chime is receiving interference from another wire-
less device.
CORRECTIVE ACTION: Reset chime.
• Unplug chime.
• Ensure switch 1 on both the chime and push button is set to OFF.
• Wait 30 seconds.
• Press and hold the push button within 20 seconds after plugging in
chime. When the "Ding" tune is played, the chime memory has been
erased.
• To re-sync the push button and chime, unplug chime. Wait 30 seconds.
• Press and hold the push button within 20 seconds after plugging in
chime. When the "Ding-Dong" tune is played, the push button is synced
with the chime.
Note: The push button and chime come synced from the factory. The range of
the wireless chime can vary with location, temperature, and battery condition.
Helpful Videos – www.hzsupport.com Helpful Answers – 1-800-858-8501
5