Heath Zenith 7366 Mode D'emploi page 2

2
Chime Volume Control
Access Door (See Tune
Settings or Troubleshooting)
Figure 2
Figure 3
Helpful Videos – www.hzsupport.com
4. Adjust volume control. Unplug chime and
adjust volume control to desired volume (see
Figure 2). Plug chime back into wall outlet.
5. Mount push button. Use either screws or
double sided tape to mount push button.
• Screw Mounting: To mount with screws,
remove back of case by pushing in tab on
bottom with a small screwdriver (see Figure
1). Note: Remove material in screw holes
(if needed) before mounting with screws.
Attach back of case to door jamb or wall (see
Figure 3). Snap front of push button on.
• Tape Mounting: When attaching push but-
ton using double sided tape, make sure the
surface of the door jamb or wall is clean.
Helpful Answers – 1-800-858-8501