Lionelo Sander Manuel De L'utilisateur page 15

To do so, slide ISOFIX guides to the back of the safety seat. The safety
seat must be in sitting position (fig. 21.1). Mount the safety seat
in accordance with ISOFIX assembly instructions described above.
Make sure the safety seat is fits tight the backrest of the car seat. Pull the safety belt.
Pull through the safety belt in the back of the backrest with marked guides (between
a frame and car seat cover), pull out a belt from the other side of the safety seat and
unlock it by inserting in the car belt clamp. Tighten the belt and see if the safety
seat has been mounted properly. If it is still slackened, tighten the belt again (fig.
22.1-22.3). Spread safety belts of the safety seat, next place the child in the safety
seat well. Combine two parts of the metal clamp. Insert two parts of the metal
clamp in the handle. If you can hear a click, the belt is locked. Make sure the belt
has been locked properly. Pull belt adjustment to tighten hardness of the safety belt.
If belts fit your child tight, it is fully protected (fig. 22.4-22.8).
Installation for Group I (9-18kg) with safety belts
The safety seat must be in a forward-facing position. Position the safety seat on the
car seat so that its backrest fits the backrest of the seat tight. Pull the safety belt.
Pull through the safety belt in the back of the backrest with marked guides
(between a frame and the safety seat cover), pull out a belt on the other side of
the safety seat and lock it by inserting in the car belt clamp. Tighten the belt and
check if it is well mounted. If it is still slackened, tighten the belt again (fig. 21.1-
21.3). Spread safety belts of the safety seat, next position your child in the safety
seat well. Combine two parts of the metal clamp. Insert two parts of the metal
clamp in the handle. If you can hear a click, the belt is locked. Make sure the belt
has been locked properly. Pull belt adjustment to tighten harness of the safety
belts. If belts fit your child tight, it is fully protected (fig. 22.4-22.8).
See fig. 23- The safety seat can be in position 1, 2 or 3
Installation for Group II and III (15-36kg) with ISOFIX
Remove the safety belts of the safety seat (see instructions below). In this position
the safety seat must be in forward-facing position, position ISOFIX handles properly
(in accordance with the description above). Mount the safety seat in accordance with
ISOFIX assembly instructions described above. Set a relevant height of the headrest
(see instructions above). Carry the car belt in front of the safety seat. Fasten the
belt clamp in the buckle and position the hip belt in lower guides. Pull through
‑ 15 ‑ EN