Publicité
Les langues disponibles
Les langues disponibles
Low Voltage
Access Cover
High Voltage
Access Cover
Indicator Light
5. Connect the Components
CAUTION: Risk of electric shock or product damage. Make sure the power cord for the media
module is unplugged or the power supply is turned off before removing the access covers.
Low Voltage Connections – Controls and Components
Note: For wireless applications an Ethernet connection is not needed.
Remove the low voltage access cover.
Remove the grommets in the locations where the cables will be installed. Refer to the "Connection
Key."
Gently press each connection until it snaps together.
Slide the cable grommet into the slot with the male end up. Verify the grommet is properly seated.
High Voltage Power Connection – International Installations
IMPORTANT! Use only copper wire for the high voltage connection.
Remove the high voltage access cover.
Remove the power cord.
IMPORTANT! To ensure proper strain relief and ingress protection, only install a cable with an outside
diameter between 4.3 mm (0.17 in) and 11.9 mm (0.45 in).
Secure the power cabling to the media module using the watertight strain relief fitting (provided).
Connect the wire for line, neutral, and ground according to the above illustration. Secure each wire
to the appropriate terminal.
Kohler Co.
Male End
Install grommets
flush with media
box.
Grommet
Make sure power cord is
unplugged before
opening access covers.
11
Slide grommet into slot with
male end up.
Hard-Wire Option (International)
Ground
Neutral
Line
Use copper
wire only.
1093174-2-C
Publicité
