Maintenance And Repair - Homa ALWS Manuel D'instructions Original

San.iQ cut & San.iQ one
25
Ø22
San.iQ cut V
Saniquick C
Ø22
San.iQ plus Standard
Ø22
Ø22
250
Ø22
35
Ø22
Ø22
95
Ø22
Ø22
San.iQ plus with special float for operation with a
shower (low switching point)
Ø22
Ø22
Sanipower
Ø22
For the Sanipower, it is only possible to install the float
on the side of the tank opposite the pressure connec-
tion.
Guide the sensor from the outside through the hole so
that the sealing ring is outside the tank and screw it on
firmly.

6. Maintenance and Repair

Ø22
Do not use the ALWS in damp rooms!
Ø22
95
25
Ø22
Ø22
For durable and perfect functioning, for each safety
device, the operation is to be checked at set interva-
ls. To do this, an alarm is to be triggered at least 1 x
month by operating the float switch by hand. Then
unplug the device and plug it back in again.
The device must be handled with care and used ac-
Ø22
cording to the technical data above (do not throw or
knock etc.).
95
Ø22
Ø22
EngliSH | 09
Ø2
95
Ø2