Wagan Tech Elite 700W PRO Guide D'utilisation page 8

Elite 700W PRO by Wagan Tech
™
oPeratInG IssUes: televIsIon and aUdIo eqUIPMent
sUGGestIons.
Although all inverters are shielded and filtered to minimize signal interference,
some interference with your television picture may be unavoidable, especially
with weak signals. However, here are some suggestions that may improve
reception.
• Make sure that the television antenna produces a clear signal under normal
operating conditions (i.e. plugged into a standard AC wall outlet). Also
ensure that the antenna cable is of good quality and properly shielded.
• Sometimes vehicle alternators produce electrical noises. There are filters
available to mount on the alternator for noise reduction.
• Change the positions of the inverter, antenna cables, and television power
cord.
• Isolate the television, its power cord, and antenna cables from the 12
volt power source by running an extension cord from the inverter to the
television.
troUbleshootInG
PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason
Poor contact with battery or inverter
terminals.
7
®
Solution
Clean terminals thoroughly. Reinstall
and tighten.
www.wagan.com