Wagan Tech Elite 700W PRO Guide D'utilisation page 7

2. Connect just the red terminal of the supplied DC Battery Clip Adapter Cord
to the red stud terminal (+) on the rear end of the inverter.
3. Connect the two battery clips to the battery.
Be sure to connect the clips to the correct polarity battery terminals.
Reverse polarity connection will blow the fuse in the inverter and can
permanently damage to the inverter. Damage caused by reverse polarity
will void the warranty.
4. Connect the Negative black (−) connector to the stud connector on the rear
end of the inverter. There may be a momentary spark and the low voltage
buzzer may briefly sound.
5. Plug the AC appliance cord into the inverter's AC outlet, and/or your USB
appliance into the USB power port.
6. Place the ON/OFF power switch in the "ON" position. The green LED
should turn on, indicating the inverter is powered and operating normally.
7. When the inverter is not in use, place the inverter's ON/OFF Power Switch
to the OFF position.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
Battery Clip Adapter Cord
©2013 Wagan Corporation. All Rights Reserved.
6