Conceptronic CM3PVRD Manuel De L'utilisateur page 38

ENGLISH
Connecting the Power Cable
When the unit is connected to your Audio/Video equipment, you can connect the power supply to the unit.
•
Connect the included power supply to the unit and to a free wall socket.
•
Set the main power switch on the back of the unit to 'I' to power the unit.
The unit will now turn on.
When the unit is powered and operational, the Navigation Buttons (7), The Record Button (2) and the
Power Button (6) will burn Blue.
When the unit is powered and in standby, the Navigation Buttons (7) will burn Red. The Record Button (2)
and Power Button (6) will not burn.
Preparing the Remote Control
•
Remove the battery cap from the back of the remote control
•
Insert the included AAA batteries in the remote control.
•
Replace the battery cap on the back of the remote control.
Notes: - The best operational range of the remote control is about 5 meters.
- Point the remote control to the IR receiver which is embedded in the front panel of the unit.
- The receiving angle of the IR receiver is ±30 degrees.
- Change the batteries when they are weak or empty.
38