Kokido TELSA 10 Manuel D'emploi page 9

Important note:
Close the protective cap tightly after charging before operation
In case, charging sockets gets wet, dry the area completely (eg, using cotton bud)
before charging.
WARNING!
DO NOT handle the pool vacuum, external adaptor and charging base while it is
charging with wet hands and without shoes.
Connect the external adaptor to the power source through a ground fault circuit
interrupter (GFCI).
Charge the pool vacuum with the original external adaptor provided.
DO NOT use power extension cords.
Fully charge the battery before first use.
Charging must be done indoors, in a dry & well-ventilated area away from sunlight,
children, heat, ignition sources, and with an ambient temperature between 5˚C (41˚F)
and 30˚C (86˚F).
Always disconnect the external adaptor from the power source when charging is
complete.
Do not leave the pool vacuum in charge for over 20 hours.
Immediately turn the power off and disconnect the external adaptor from the power
source if you detect any of the following conditions:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
1. Make sure that the pool vacuum is turned off prior to charging.
2. Connect the external adaptor to the power source. Once the pool vacuum begins
charging, the indicator light on the external adaptor will turn red. Normally, it takes
about 4- 5 hours to reach a full charge. The indicator light will turn green when the
pool vacuum is almost fully charged.
Note: If the motor is generating noise, immediately turn off the device by pressing the
ON/OFF button. Otherwise, it could potentially lead to failure of the shaft seals / motor,
and the warranty will be voided as a result.
Note: Charge the pool vacuum completely (about 4-5 hours) prior to the first use.
3. When charging is complete, disconnect the external adaptor from the power source
and unplug the jack from the charging base.
4. Detach the charger base from the pool vacuum.
8