Publicité
Les langues disponibles
Les langues disponibles
TOOLS / ASSEMBLY
4 mm Allen Key (included)
Electric Screwdriver
and/or Power Drill
Nr.
Part
Qty
1
Leg
2
Foot
3a
Frame End-CB
3b
Frame End
4
Center Rail
5
6
Side Bracket
6
Control Box
Handset
7
10
Tape Measure
Nr.
Part
2
8
Power Cord
9
2
Cable (1.3m)
1
10
M6 x 10 Machine Screw
1
11
M6 x 14 Machine Screw
2
12
M5 x 20 Wood Screw
2
13
6
M5 x 16 Wood Screw
1
14
Cable Clip
1
ENGLISH
ENGLISH
ASSEMBLY
1.
Lay out all components and hardware to ensure that you have all the components and hardware listed on the parts poge.
(part 6)
Slide the Control Box
(part 3a).
Frame End-CB
You will find the Center Rails
Qty
1
1
16
12
11
2
10
(part 3a)
off the Frame End-CB
and set aside. Fully separate Frame End
(part 4)
inside.
(part l)
2.
Place one of the Legs
into the Frame End-CB
(part l )
bar (arrow) is on „top" in relation to the Leg
(part l)
(part 3a)
with the holes on the Frame End-CB
(part 10)
insert four (4) M6 x 10 Machine Screws
(part 3a)
(part l)
End-CB
, going into the Leg
turns. After all the four (4) M6 x 10 Machine Screws
the four (4) screws. Do the same for the other Leg
3b)
. If you drop a screw inside the frame end, simply tilt to retrieve.
If you drop a screw inside the frame end, simply tilt to retrieve.
(part 3a)
3.
The Frame End-CB
should be placed on the side of the desk where you
(part 6)
plan to attach the Control Box
and the Handset
(part 5)
Slide the Side Bracket
into the Frame End-CB
(part l l)
M6 x 14 Machine Screws
through the two (2) holes in the bottom of
the frame end/leg assembly and into the tabs in the Side Bracket
Using the supplied Allen Key, rotate each screw just a few turns. After both
M6 x 14 Machine Screws are inserted, tighten both screws.
Do the same for the other frame end/leg assembly.
4.
Slide the two (2) Center Rails
(parts 3a & 3b)
Frame Ends
a) the slots in the Center Rails
b) the slots in the Center Rails
to the top edge, as assembly is carried out upside
down (see inset).
5.
For each leg assembly, attach a Foot
four (4) M6 x 14 Machine Screws
tighten in a cross-pattern.
(part 3b)
from
(part 3a)
ensuring that the
. Line up the holes on the Leg
. Using the supplied Allen Key,
through the holes in the Frame
and rotate each screw just a few
(part 10)
are inserted, tighten
(part l)
(part
and the Frame End
(part 7)
.
(part 3a)
. Insert two (2)
(part 5)
.
(part 4)
into the two
ensuring that:
(part 4)
face inward
(part 4)
are closer
(part 2)
with
(part 11)
and
11
Publicité
