Using The Tamper - Klarstein 10027868 Mode D'emploi

Soy Milk
The tamper is to be used for stirring food and reading the food temperature in the blender jar.
Never use the tamper without the lid in place. Remove the fi ller
cap from the lid and slide tamper into the Blender Jar. The tam-
per has a splash guard located near the top that prevents the
tamper from coming in contact with the blade assembly.
The maximum temperature for the tamper is 100°C. To take a
temperature reading simply press the temperature button loca-
ted on top of the tamper. The temperature is read by a sensor
located at the bottom of the tamper.
You can turn the temperature sensor off by pressing the tempe-
rature button; otherwise it will automatically shut off after 120
seconds.
Changing the Tamper Battery
• Open the Top Cover by turning counter-clockwise.
• Remove the PCB Assembly from the Tamper being careful not
to pull the wire connector.
• Locate the battery on the underside of the PCB Assembly. Sli-
de out the battery from under the bracket. Slide a new battery
into the bracket and replace the PCB Assembly and Top Cover.
Use only battery type CR2032.
15
Accelerate from speed 1 to speed 5 in 5 sec, and run at
speed 8 for 30 sec; fi nally speed H until fi nish. Total time is
6 min.

Using the Tamper