LF MASTER FORGE MFA350BNP Mode D'emploi page 9

ASSEMBLY INSTRUCTIONS
5. Remove preassembled screws (FF) from the
door handle. Insert the 2 door handle sleeves
(X) into the holes located on the back of the
door assembly (H). Insert 2 screws (FF) into
the door handle sleeves (X), through the door
handle bezels (J) and into the threaded holes
in the door handle (I). Tighten the screws.
Hardware Used
FF
6. Attach the door assembly (H) to the assembled
cart body by aligning the holes in the hinge of
the door assembly with the holes in the cart
left side panel (D), inserting 4 screws (BB)
and tightening. Adjust the door assembly (H)
clearance to the cart body by slightly loosening
the 4 screws (BB), aligning the door assembly
(H) with the cart body, then tightening all
screws (BB) securely.
Hardware Used
BB
7. Slip control knobs (K) onto the valve stems
located on the front control panel of the grill
body (L). Remove preassembled screws (GG)
from the lid handle. Attach the lid handle (U)
by inserting two screws (GG) from inside the
lid of the grill body (L), through the lid handle
bezels (V), into the handle (U) and tightening
securely.
Hardware Used
GG
5
J
I
6
H
7
U
9
FF
X
BB
D
V
L
TT
H
E
GG