LF MASTER FORGE MFA350BNP Mode D'emploi page 18

CARE AND MAINTENANCE
CLEANING THE BURNER ASSEMBLY
– Make sure the grill is cool
1. Turn gas off at the control knobs and propane tank.
2. Disconnect LP-Gas cylinder from hose and regulator.
3. Remove warming rack, cooking grates and heat tents.
4. Detach burner by removing the cotter pins at the back of the burners to detach them from the brackets.
5. Detach ignition wire from electrode by hand only. DO NOT use pliers or any other tool as it may
damage the electrode or wire.
6. Lift burner slowly.
7. Ensure all burner ports are clear of clogs. Use of a pin or paper clip works well.
8. Ensure burner is free of any damage. If damage is found, replace with new burner.
9. Ensure the end of the burner and primary air screen are clear from insect nests, dirt or debris.
RE-INSTALLING THE BURNER
Ensure that gas valve orifices are correctly positioned inside burner inlet (venturi).
The use of a flashlight may be necessary to ensure the correct position.
If the instructions above are not followed, a fire or explosion may result, possibly
causing serious bodily injury or death.
OTHER CARE AND MAINTENANCE
It is recommended that inspection and service on this appliance be conducted annually by a qualified
service person.
It is recommended that you regularly check that the outdoor cooking appliance area is clear and free
from combustible material, gasoline and other flammable vapors and liquids.
It is recommended that you regularly check that the flow of combustion and ventilation air is not
obstructed.
It is recommended that you regularly check that the ventilation openings of the cylinder enclosure
(cabinet) are free and clear from debris.
It is recommended that you regularly check and clean the burner/venturi tubes for insects and insect
nests. A clogged tube can lead to a fire beneath the grill.
WARNING
18