Custom Panel - Sub-Zero UC15IPO Mode D'emploi

IN S TA L L AT I O N

Custom Panel

O VER L AY PA NE L
For overlay applications, a custom door panel must be
installed. Panel size is critical for a proper fit. To verify panel
requirements and dimensions, refer to the Sub-Zero design
guide at subzero.com/specs.
Finish all sides of the custom panel. They will be visible
when the door is open.
A D-style handle is recommended. The door handle must be
located near the edge of the panel opposite the hinge, cen-
tered top to bottom. Stainless steel tubular and pro handles
are avail able through an authorized Sub-Zero dealer. For
local dealer information, visit the find a showroom section
of our website, subzero.com.
|
10 Sub-Zero Customer Care 800.222.7820
PAN EL IN STAL LATIO N
Remove the handle side bracket attached to the front of the
door. Place the custom door panel face down on a pro-
tected work surface. Place the template on the back of the
door panel, then mark and drill holes. Secure the mounting
bracket to the panel with the #8 x
Refer to the illustration below.
Install the door panel by engaging the tabbed bracket to
the door. Once the door panel is in place, use the remaining
#8 x 1 / " screws to secure the panel to the upper and lower
2
mounting brackets. Once secure, install the hinge covers.
Refer to page 11.
Template position
1 / " screws provided.
2
UPPER
BRACKET
LOWER
BRACKET
Mounting brackets