Remove The Battery Pack; Operation; Cold Weather Operation; Blue Led Light - GreenWorks Pro SNB403 Manuel D'opérateur

WARNING
• LED light flashes blue if the battery voltage is lower,
bring the battery into a room temperature area to charge
until the green charger light is always on.
• Blue LED light is always on if the battery temperature
is lower, bring the battery into a room temperature area
to drop the temperature. Once the charger light flashes
green, the battery can be installed for use.
1. Open the battery door (5).
2. Align the ribs on the battery pack (20) with the grooves in
the battery compartment.
3. Push the battery pack (20) into the battery compartment
until the battery pack (20) locks into place.
4. When you hear a click, the battery pack (20) is installed.
5. Close the battery door (5).
7.7

REMOVE THE BATTERY PACK

1. Open the battery door (5).
2. Push and hold the battery release button (21).
3. Remove the battery pack (20) from the machine.
8

OPERATION

WARNING
Wear eye protection during operation.
8.1

COLD WEATHER OPERATION

The safe battery operation temperature ranges from 1°F
(-17°C) to 113°F (45°C).
WARNING
Do not store or charge battery outside.
Battery must be charged and stored indoors prior to use of the
machine.
If the machine does not start:
• remove the battery pack from the machine,
• charge the battery pack to 15 minutes in warm area, or
when the charging light turns green.
• Install the battery pack back in the unit.
English
8.2

BLUE LED LIGHT

1. LED light flashes blue if the battery voltage is low. Place
the battery in a room temperature area and charge until
the green charger light is flashing green.
2. Blue LED light (34) is always on if the battery
temperature is low. Bring the Battery and Charger in to a
warm area. Place the Battery in the charger and allow for
the battery to reach room temperature or when the light
on the charger is flashing Green. Once charger is flashing
green, take the battery and place it in the unit to begin
work.
8.3

START THE MACHINE

1. While holding the safety switch button (3), pull the bail
lever (2) to start the machine.
Lower the scraper to the ground to remove the snow.
Keep bystanders a safe distance from the machine.
Examine the work area. Remove all stones, sticks, wire,
bones, and other debris that can ricochet because of the
rotating impeller.
8.4

STOP THE MACHINE

1. Release the bail lever (2) to stop the machine.
9
34
NOTE
WARNING
WARNING
EN