Hard Head 021094 Traduction Des Instructions D'origine page 26

EN
power cord and plug by plugging the plug.
1. Status light
2. Adjusting lever
The status light (1) goes on when the product
is in heating mode. The status light (1) goes off
when the water reaches the set temperature to
indicate that the product is not heating.
FIG. 13
TEMPERATURE SETTING
The required temperature can be set with the
dial on the control panel.
FIG. 13
OVERHEATING PROTECTION
The product has over heating protection that
switches off the power to the product if the
temperature of the water is too hot.
WARNING!
If the overheating protection trips it will not
reset automatically and the product will not
work. Contact an authorised service centre.
MAINTENANCE
Clean the product as necessary with a soft,
damp cloth. Do not use abrasive detergent or
solvent on the product. Do not spray water or
any other liquid on the product.
The magnesium sacrificial anode protects the
inside of the water tank from corrosion. The
anode becomes consumed in time and must
be replaced at regular intervals.
The manufacturer recommends that qualified
personnel check the anode at regular intervals
and replace it when necessary for best results
and life span. This check should be included
in the regular preventive maintenance of the
product.
26
Contact an authorised service centre for
replacement anodes.
Scale forms in time during normal use on
the surface of the heater element. Such
deposits reduce the transfer of heat between
the heater element and the water. A higher
surface temperature on the heater element is
required to heat the water. The thermostat will
switch on and off more often. The overheating
protection can trip. The manufacturer
recommends preventive maintenance every
other year by an authorised service centre
to avoid such problems. Such preventive
maintenance should include cleaning and
checking the sacrificial anode (for products
with glass ceramic coating). The sacrificial
anode should be replaced when necessary.
The manufacturer cannot accept liability for
any damage resulting from failure to follow
these instructions.