Cequent Performance Products 24778 Instructions D'installation

Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24778F
Wrenches: 17mm., 3/4"
Drill Bits: None
FIGURE 1
j
Qty. (2) Hex Bolt, M10 x 1.25 x 40mm
k
Conical Washer, 7/16"
Qty. (2)
l
Carriage Bolt, 1/2 x 13 x 2"
Qty. (1)
1. On dual exhaust models, loosen the rear exhaust hangers and lower the exhaust.
2. Remove and dispose of rear rubber weld nut covers as shown in Figure 1.
3. Raise hitch into position as shown in Figure 2.
4. Tighten all fasteners.
5. If necessary, raise the exhaust back into position and reattach to the exhaust hangers.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2005, 2006, 2015 Cequent Performance Products – Printed in Mexico
Installation Instructions
Fascia
(Sold separately)
Drawbar Kit:
3594
Drawbar must be used in the
RISE position only.
Frame Rail
Rubber
Weld Nut
Cover
Both Sides
Tighten all 1/2" GR5 fasteners with torque wrench to 50 lb-ft (68 N-m).
Tighten all M10 CL8.8 fasteners with torque wrench to 42 lb-ft (57 N-m).
Kia Optima
Kia Magentis
Do Not Exceed Lower of Towing Vehicle
2000 lb. (908 kg) Max Gross Trailer Weight
200 lb. (90.8 kg) Max Tongue Weight
Wiring Access Location: PC3, 4
m
Qty. (1) Spacer
n
Conical Washer, 1/2"
Qty. (1)
o
Qty. (1) Nut
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
FIGURE 2
24778N 10-13-15
24778
60848
77154
Existing
Weld Nuts
Both Sides
Rev. C