How To Use; Loading The Wire Coil - Senco SRT25 Mode D'emploi

How to use

Loading the wire coil.

WARNING! Set the main switch in OFF po-
!
sition, activate the trigger lock and remove
the battery�
1. Push the release lever until it is caught by the
release stopper�
Release lever
Release stopper
2. Push the reel stopper to open the reel stay�
Reel stopper
3. Insert the wire coil with the wire-end upwards and
forward. Carefully close the reel stay and secure the
reel stopper�
4. Release the wire and remove the rubber band�
5. Insert the tip of the wire into wire guide C, through
the gap of the feeding gears and all the way into the
pipe. (10 - 20 mm)
10-20 mm
Pipe
Wire guide C
Reel stay
If the window is dirty and it is difficult to deter-
mine the position of the wire guide C.
Clean the inside of the window with a soft cloth.
Close the window again to prevent the ingress of
foreign bodies in the machine.
6. Push the release stopper and make sure that the
release lever is back in original position and that the
feeding gears are clamping the wire.
Feeding gears
Release lever
7. Make sure that the wire is tight and firm. Prevent
the wire from curling up behind the wire coil. This
may cause a jam�
WARNING! When the main switch is set
!
to ON, do not place your fingers near the
machine mouth or other moving parts of the
machine! Avoid switching the main switch repeatedly
between ON and OFF� This can cause a machine
breakdown� Do not touch the wire while the machine
is running�
8. Slide in the battery and set the main switch to ON�
9. Release the trigger lock, before starting to tie.
Trigger lock
Release stopper
EN
9