Restrictor; Surface Nozzle; Spatula Nozzle; Cleaning/Maintenance/Storage - Deltafox DP-EHG 2050S Traduction De La Notice D'utilisation Originale

Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.

Restrictor

Place the restrictor (5) on the blow-off
pipe (4).
Use the restrictor (5) to obtain selective
heat.
When using the restrictor (5), pay
particular attention to the heat de-
velopment at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.

Surface nozzle

Place the surface nozzle (6) on the blow-
off pipe (4).
Use the surface nozzle (6) to obtain heat
over a large surface.
When using the surface nozzle
(6), pay particular attention to the
heat development in adjacent loca-
tions of the cutting point. So that in
cases of doubt, no adjacent com-
ponent is overheated.

Spatula nozzle

Place the spatula nozzle (7) on the blow-
off pipe (4).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints
and lacquers can be removed with a
spatula and scraper. The spatula (7) itself
is not suitable for removing paint.
Cleaning/maintenance/

storage

Ask our service centre to carry out
any work that is not described in
these instructions. Do not try to re-
pair the device by yourself, unless
you have professional training.
Use only original parts.
• Store the device in a dry place and
out of reach of children.
General cleaning and mainte-
nance work
• Always keep the device clean. Use a
brush or cloth for cleaning, but do not
use any cleaning agents or solvents.
Storage
• Store the appliance in a dry place well
out of reach of children.
• Give the device time to cool down
before you store the device in an en-
closed space.
We are not liable for damages caused
by our equipment. Insofar as these are
caused by improper repair or the use of
non-original parts or use contrary to in-
structions.
Waste disposal and
environmental protection
Be environmentally friendly. Return the
tool, accessories and packaging to a
recycling centre when you have finished
with them.
Electrical machines do not belong
with domestic waste.
GB
15