LGB 99 7818 Serie Mode D'emploi page 8

Smoke Generator
This model is equipped with a smoke generator. A small
supply of LGB Smoke and Cleaning Fluid is included with this
model. For best operation, fill the generator halfway with
fluid. If the generator is overfilled, it will not convert the fluid
into smoke.
Attention! Only use LGB Smoke and Cleaning Fluid (50010).
Other fluids may damage your locomotive.
Attention! Never touch the heating element in the center of
the smoke generator. It is hot and fragile.
SERVICE
Lubrication
The axle bearings and the side rod bearings should be lubri-
cated occasionally with a small amount of Märklin-Oil (7149).
Replacing the light bulbs
Front/rear lanterns: Remove the ring around the lantern lens.
Carefully pry the lens away from the lantern. Using
tweezers, remove and replace the bulb. Reassemble.
Cab light: Using tweezers, remove and replace the bulb.
Replacing the smoke generator
• Pull the safety cover out of the smoke stack (Fig. 3).
• Use pliers or tweezers to pull the old smoke generator out
of the stack (Fig. 4).
• Cut the wires to the old generator and attach them to the
replacement generator (Fig. 4).
• Insulate the connections and push the replacement
generator into the stack.
• Reassemble.
7