Kohler K-638 Guide Du Propriétaire page 6

Low Voltage
Access Cover
Indicator Light
High Voltage
Access Cover
Connect the Components
CAUTION: Risk of electric shock or product damage. Make sure the power cord is unplugged
before removing the access covers.
NOTE: If the power cord is damaged, it must be replaced by the manufacturer, its service agent, or a
similarly qualified person in order to avoid hazard.
Note: For wireless applications an Ethernet connection is not needed.
Remove the low voltage access cover.
Remove the grommets in the locations where the cables will be installed. Refer to the "Connection
Key."
Gently press each connection until it snaps together.
Slide the cable grommet into the slot with the male end up. Verify the grommet is properly seated.
Reinstall the access covers. Do not overtighten.
Plug the power supply into the outlet. Verify that the indicator light turns on and pulses.
Test each component to ensure proper functionality. Refer to the Installation and Homeowner
Guides packed with each of the individual components for additional information.
1069763-5-F
Male End
Install grommets
flush with media box.
Grommet
Make sure power cord is unplugged
before opening access covers.
6
Slide grommet into slot with
male end up.
Kohler Co.